Chevrolet Sonic Repair Manual: Camshaft Sprocket Installation
- Install the intake camshaft sprocket (3).
- Install the intake camshaft position sensor exciter wheel (2) and the intake camshaft sprocket bolt (1), but do not tighten yet.
- Install the exhaust camshaft sprocket.
- Install the exhaust camshaft position sensor exciter wheel and the exhaust camshaft sprocket bolt, but do not tighten yet.
Note:
Tightening of camshaft sprocket bolts will be done after the engine front cover installation.
Camshaft Gears
...
Camshaft Sprocket Removal
Loosen the intake camshaft sprocket bolt (1) while holding the hexagon of
intake camshaft (2) with a wrench.
Remove the intake camshaft sprocket bolt (1) and the ...
Other materials:
Rear Side Door Weatherstrip Replacement - Door Side
Rear Side Door Weatherstrip Replacement - Door Side
Callout
Component Name
1
Rear Side Door Weatherstrip
Procedure
Open the front side door to the fully open position.
Remove the front side door check link bo ...
Instrument Panel Insulator Replacement
Instrument Panel Insulator Replacement
Callout
Component Name
Preliminary Procedures
Disable the SIR system. Refer to SIR Disabling and Enabling.
Remove the passenger inflatable restraint instrument panel lower
module ...
Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral
(N) position, the transmission will provide engine braking. In this operating range,
the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine
braking mode, the following changes occur with ...
0.0057