Chevrolet Sonic Repair Manual: Camshaft Timing Chain Installation
Special Tools
- EN-952 Fixing Pin
- EN-953-A Fixing Tool
- EN-955-10 Fixing Pin from EN-955 Kit
For equivalent regional tools, refer to Special Tools.
- The engine should be adjusted to TDC.
- The crankshaft should be locked with EN-952 fixing pin.
- The camshaft should be locked with EN-953-A fixing tool.
- Install the timing chain (1) along with the crankshaft sprocket (2).
- Install the timing chain tensioner shoe (1).
- Install the timing chain tensioner shoe bolt (2) and tighten to 20 Y (15 lb ft)
.
- Install the timing chain guide right side (1).
- Install the 2 timing chain guide right side bolts (2) and tighten to
8 Y (71 lb in)
.
- Push the timing chain (2) in direction to the timing chain tensioner (1) and remove the EN-955-10 fixing pin (3).
Caution:
Refer to Fastener Caution.
The upper timing chain guide will be installed after the installation of the engine front cover and the fastening of the camshaft sprockets.
Camshaft Timing Chain Inspection
Special Tools
EN-952 Fixing Pin
EN-953-A Fixing Tool
EN-49977-100 Transmitter Disc Fixation
For equivalent regional tools, refer to Special Tools.
Remove the ignition coil. Refer to I ...
Camshaft Timing Chain Removal
Special Tools
EN-952 Fixing Pin
EN-953-A Fixing Tool
EN-955-10 Fixing Pin from EN-955 Kit
For equivalent regional tools, refer to Special Tools.
The engine should be adjusted to TDC.
...
Other materials:
Battery Load Management
The vehicle has Electric Power Management (EPM) that estimates the battery's
temperature and state of charge. It then adjusts the voltage for best performance
and extended life of the battery.
When the battery's state of charge is low, the voltage is raised slightly to
quickly bring t ...
Transmission Control Lever Boot Replacement
Transmission Control Lever Boot Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console. Refer to Front
Floor Console Replacement.
1
Shift Control Lever Knob Cove ...
Engine Replacement (Manual Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover .
CH-807 Closure Plugs .
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Relieve the fuel system pressure. Refer to
...
0.0059