|
Callout |
Component Name |
|---|---|
Preliminary Procedure
|
|
|
1 |
Center Pillar Lower Trim Panel Assembly Procedure
Ensure the seat belt webbing does not become trapped during installation. |
Cargo Tie Down Loop Replacement
Center Pillar Upper Trim Panel ReplacementPark - Engine Running (Gen 1)
When the gear selector lever is in the Park (P) position, fluid is drawn into
the pump through the transmission fluid filter assembly. Line pressure is then directed
to the following valves:
Fluid Pressure Directed in Preparation for a Shift
Manual Valve
Mechanically controlled by ...
Intake Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...
I-BSI system operation
Example
Side indicator light
I-BSI ON indicator (vehicle information display)
I-BSI indicator (vehicle information display)
ProPILOT Assist switch (design may vary depending on Nissan Armada model)
The Nissan Armada I-BSI system becomes active at speeds above approximately 37
MPH ...