Communication Interface Module Battery Replacement
Charging System Description and OperationTurbocharger Oil Feed Pipe Replacement
Removal Procedure
Open the hood.
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat
Shield Replacement.
Remove the turbocharger oil feed p ...
K20 Engine Control Module: Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the control module is not properly configured
with the correct ...
Differential Case Assemble
Special Tools
J-810721 Axle Shaft Seal Remover Support Base
R-0407011 Bearing Race Remover
R-0407012 Differential Carrier Cone Bearing Cap Driver
R-0007761 Universal Handle for Pullers and Installers
S-9407194 Speed Sensor Impeller Ring Installer
S-9407195 Pinion Gear Case Bearing I ...