Chevrolet Sonic Repair Manual: Chassis
- Brakes
- Steering
- Hydraulic Steering
- Steering Control
- Steering Gear Assembly
- Tie Rods and Linkage
- Steering Wheel and Column
- Suspension
- Drivetrain and Front Suspension Frame Replacement
- Drivetrain and Front Suspension Frame Skid Plate Replacement
- Front Suspension Description and Operation
- Front and Rear Suspension Modification Kit Installation
- Rear Axle Replacement
- Rear Suspension Description and Operation
- Special Tools
- Trim Height Inspection
- Ball Joint Inspection
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Rear Compartment Lid Hinge Torque Rod Replacement
- Lower Control Arm Replacement
- Front Wheel Bearing and Hub Replacement
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Front Wheel Bearing and Hub Replacement
- Hub/Axle Flange and Wheel Stud Runout Inspection
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
- Steering Knuckle Replacement
- Liftgate Strut Replacement
- Strut Assembly Removal and Installation
- Strut, Strut Component, or Spring Replacement
- Shock Absorber Disposal
- Shock Absorber Replacement
- Strut and Shock Absorber Inspection
- Strut and Shock Absorber Inspection (Shock Absorber)
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Stabilizer Shaft Link Replacement
- Stabilizer Shaft Replacement
- Brake Control and Vehicle Dynamics
- Wheels/Tires
Windshield Wiper Motor Replacement
Windshield Wiper Motor Replacement
Callout
Component Name
Preliminary Procedure
Remove the wiper system module. Refer to Windsh ...
Brakes
...
Other materials:
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
Back-up Lamp
Turn Signal Lamp
Stop Lamp/Taillamp
Sidemarker Lamp
To replace one of these bulbs:
Open the trunk.
Remove the two screws, which secure the taillamp assembly.
Remove the taillamp assembly by pulling it straight ...
Intake Manifold Removal
Note: Intake manifold bolts remain in intake manifold screw bores.
Remove the 6 intake manifold bolts (1).
Remove the intake manifold (1) along with the intake manifold gasket.
...
Engine Front Cover with Oil Pump Replacement
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Set the engine to TDC. Refer to Camshaft Timing Chain Inspection.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove ...
0.0107