Chevrolet Sonic Repair Manual: Clutch Actuator Cylinder Front Pipe Replacement
- Removal Procedure
-
- Remove the battery tray. Refer to Battery Tray Replacement.
- Remove as much brake fluid out of brake fluid reservoir as possible.
- Unclip the clutch actuator cylinder front pipe from the 2 retainers (1).
- Remove the retaining clip (1).
- Disconnect clutch actuator cylinder front pipe (3) from the clutch master cylinder (2).
- Remove the retaining clip (1).
- Disconnect the clutch actuator cylinder front pipe (2) from the clutch actuator cylinder pipe elbow.
- Remove the clutch actuator cylinder front pipe from the vehicle.
- Installation Procedure
-
- Install the clutch actuator cylinder front pipe in the vehicle.
- Connect the clutch actuator cylinder front pipe (2) to the clutch actuator cylinder pipe elbow.
- Install the retaining clip (1).
- Connect clutch actuator cylinder front pipe (3) to the clutch master cylinder (2).
- Install the retaining clip (1).
- Clip the clutch actuator cylinder front pipe into the 2 retainers (1).
- Install the battery tray. Refer to Battery Tray Replacement.
- Bleed the hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding.
- Fill the reservoir with GM approved brake fluid from a clean, sealed brake fluid container up to the MAX level.
Exhaust Manifold with Catalytic Converter Replacement (LUW)
Exhaust Manifold with Catalytic Converter Replacement
Callout
Component Name
Warning: Refer to Protective Goggles and Glove Wa ...
Exhaust Front Pipe Replacement (LUV,LUW)
Removal Procedure
Warning: Refer to Exhaust Service Warning.
Remove the drivetrain and front suspension frame skid plate. Refer to
Drivetrain and Front Suspension Frame Skid ...
Other materials:
Radio Controls with Touchscreen
The infotainment system is operated by using the pushbuttons, menus shown on
the display, and steering wheel controls.
Turning the System On or Off
(Power): Press and hold to turn
the radio on and off.
Automatic Switch-Off
If the infotainment system has been turned on after the ignition is ...
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat.
2. Remove the wheel cover, if the vehicle has one, to reach the wheel bolts.
3. Turn the wheel nuts counterclockwise to loosen them. Do not remove them yet.
4. Place the jack at the position marked with a half circle.
5. In ...
Instrument Panel Lower Compartment Replacement
Instrument Panel Lower Compartment Replacement
Callout
Component Name
Preliminary Procedure
Open the instrument panel lower compartment to the full open position.
Disconnect the instrument panel compartment dampener from t ...
0.0091