Chevrolet Sonic Repair Manual: Clutch and Differential Housing Cleaning and Inspection

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Manual / General / Clutch and Differential Housing Cleaning and Inspection

Warning:

Wear safety glasses to avoid injury when using compressed air or any cleaning solvent. Bodily injury may occur if fumes are inhaled or if skin is exposed to chemicals.

Clean the clutch housing (1) with a suitable solvent. Air dry all the parts.
Inspect the clutch housing for the following conditions:

Cracks
Replace the clutch housing if cracks are found.
Scratches
Burrs
Nicked mounting surfaces
Damaged sealing surfaces
Damaged front or rear bearing bores
Damaged alignment pins

Inspect the machined mating surfaces for flatness. Check the mating surfaces with a straight edge.

Inspect the bearing bores for wear, scratches or grooves.

Inspect the bushings for excessive wear. Replace worn bushings.

Use a fine mill file to dress minor scratches or burrs.

If scratches, or grooves or scoring cannot be removed by hand with a soft stone or crocus cloth, replace the component.

Clutch and Differential Housing Assemble

Special Tools R-0007761 Universal Handle for Pullers and Installers R-0407009 Countershaft Front Bearing Driver R-0407010 Input Shaft Needle Bearing Puller and Driver R-0407014 Gearshift De ...

Clutch and Differential Housing Disassemble

Special Tools M-680770 Universal Sliding Mallet R-0007758 Holding Fixture R-0407008 Counter Shaft Bearing Remover R-0407010 Input Shaft Needle Bearing Puller and Driver R-0407013 Gearshi ...

Other materials:

Front End Upper Tie Bar Replacement
Front End Upper Tie Bar Replacement Callout Component Name Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling. Remove the front fascia. Refer to Front Bumper Fascia Replacement. Rem ...

Battery Charging
Special Tools EL 50313 Battery Tester For equivalent regional tools, refer to Special Tools. Diagnostic Aids For best results, use an automatic taper-rate battery charger with a voltage capability of 16 V. The charging area should be well ventilated. Do not charge a bat ...

Inspection/Maintenance Complete System Set Procedure
Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic cat ...

0.008