Chevrolet Sonic Repair Manual: Communication Interface Module Battery Replacement

Chevrolet Sonic Repair Manual / Accessories / Electronics / Communication Interface Module Battery Replacement

Communication Interface Module Battery Replacement
Callout	Component Name
Preliminary Procedure Remove the instrument panel lower compartment. Refer to Instrument Panel Lower Compartment Replacement
1	Communication Interface Module Battery Procedure Disconnect the electrical connector. Reprogramming of the module may be necessary after losing battery power. For programming and set up procedures, refer to Control Module References.

Electronics

...

Communication Interface Module Bracket Replacement

Communication Interface Module Bracket Replacement Callout Component Name Preliminary Procedure Remove the instrument panel low ...

Other materials:

Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features ...

Ignition and Start Switch Replacement
Ignition and Start Switch Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the ignition and start switch ...

Passenger Compartment Air Filter Replacement (LHD)
Passenger Compartment Air Filter Replacement Callout Component Name Preliminary Procedure Remove IP compartment. Refer to Instrument Panel Lower Compartment Replacement. 1 Passenger Compartment A ...

0.0064