Chevrolet Sonic Repair Manual: Communication Interface Module Replacement

Chevrolet Sonic Repair Manual / Accessories / Electronics / Communication Interface Module Replacement

Communication Interface Module Replacement
Callout	Component Name
Preliminary Procedure Remove the instrument panel lower compartment. Refer to Instrument Panel Lower Compartment Replacement. Remove the instrument panel insulator. Refer to Instrument Panel Insulator Replacement.
1	Communication Interface Module Procedure Slide the module forward and release from tabs on bracket. Disconnect the electrical connections. If replacing the communication interface module be sure to transfer wireless communication interface antenna, if equipped. For programming and set up procedures, refer to Control Module References.

Communication Interface Module Bracket Replacement

Communication Interface Module Bracket Replacement Callout Component Name Preliminary Procedure Remove the instrument panel low ...

Mobile Telephone Microphone Replacement

Mobile Telephone Microphone Replacement Callout Component Name Preliminary Procedure Remove the dome lamp bezel. Refer to Dome ...

Other materials:

Engine Coolant Temperature Warning Light
This light comes on briefly while starting the vehicle. If it does not, have the vehicle serviced by the dealer. If the system is working normally the indicator light goes off. Caution The engine coolant temperature warning light indicates that the vehicle has overheated. Driving with this ...

Rear Wheel Speed Sensor Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the rear wheel speed sensor ...

Exhaust Camshaft Installation
Note: Mind the markings on the camshaft bearing caps. Camshaft bearing caps should be installed in their original position. Lubricate camshaft and camshaft bearing caps with engine oil. Install the exhaust camshaft (3). Install the 5 camshaft bearing caps̴ ...

0.0064