Chevrolet Sonic Repair Manual: Communication Interface Module Replacement

Chevrolet Sonic Repair Manual / Accessories / Navigation and Telematics / Communication Interface Module Replacement

Communication Interface Module Replacement
Callout	Component Name
Preliminary Procedure Remove the instrument panel lower compartment. Refer to Instrument Panel Lower Compartment Replacement. Remove the instrument panel insulator. Refer to Instrument Panel Insulator Replacement.
1	Communication Interface Module Procedure Slide the module forward and release from tabs on bracket. Disconnect the electrical connections. If replacing the communication interface module be sure to transfer wireless communication interface antenna, if equipped. For programming and set up procedures, refer to Control Module References.

Communication Interface Module Bracket Replacement

Communication Interface Module Bracket Replacement Callout Component Name Preliminary Procedure Remove the instrument panel low ...

Home Page (Radio with Touchscreen)

Touchscreen Buttons Touchscreen buttons show on the screen when available. When a function is unavailable, the button may gray out. When a function is selected, the button may highlight ...

Other materials:

Loss of Control
Skidding There are three types of skids that correspond to the vehicle's three control systems: Braking Skid — wheels are not rolling. Steering or Cornering Skid — too much speed or steering in a curve causes tires to slip and lose cornering force. Acceleration Skid — too muc ...

Parking Brake
To set the parking brake, hold the brake pedal down and pull up on the parking brake lever. If the ignition is on, the brake system warning light will come on. See Brake System Warning Light. To release the parking brake, hold the brake pedal down. Pull the parking brake lever up until you ...

Camshaft Timing Chain Installation
Special Tools EN-952 Fixing Pin EN-953-A Fixing Tool EN-955-10 Fixing Pin from EN-955 Kit For equivalent regional tools, refer to Special Tools. The engine should be adjusted to TDC. The crankshaft should be locked with EN-952 fixing pin. The camshaft should be locked with EN-9 ...

0.0054