Chevrolet Sonic Repair Manual: Communication Interface Module Replacement

Chevrolet Sonic Repair Manual / Accessories / Personal Communications / Communication Interface Module Replacement

Communication Interface Module Replacement
Callout	Component Name
Preliminary Procedure Remove the instrument panel lower compartment. Refer to Instrument Panel Lower Compartment Replacement. Remove the instrument panel insulator. Refer to Instrument Panel Insulator Replacement.
1	Communication Interface Module Procedure Slide the module forward and release from tabs on bracket. Disconnect the electrical connections. If replacing the communication interface module be sure to transfer wireless communication interface antenna, if equipped. For programming and set up procedures, refer to Control Module References.

Communication Interface Module Bracket Replacement

Communication Interface Module Bracket Replacement Callout Component Name Preliminary Procedure Remove the instrument panel low ...

Mobile Telephone Microphone Replacement

Mobile Telephone Microphone Replacement Callout Component Name Preliminary Procedure Remove the dome lamp bezel. Refer to Dome ...

Other materials:

Using the Tire Sealant and Compressor Kit to Temporarily Seal and Inflate a Punctured Tire
When using the tire sealant and compressor kit during cold temperatures, warm the kit in a heated environment for five minutes. This will help to inflate the tire faster. If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning fl ...

Front Wheelhouse Liner Inner Front Extension Replacement (Right Side, LUV)
Front Wheelhouse Liner Inner Front Extension Replacement Callout Component Name Preliminary Procedure Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the front fascia opening l ...

Piston and Connecting Rod Assemble
Special Tools EN-49941 Remover / Installer Piston Retainer Ring For equivalent regional tools, refer to Special Tools. Note: Lubricate the piston pin with clean engine oil. Install the connecting rod (3) and the piston pin (2) to the piston (1). Install t ...

0.0041