Chevrolet Sonic Owner's Manual: Conference Calling
Conference calling and three-way calling must be supported on the Bluetooth phone and enabled by the wireless service carrier to work.
To start a conference while in a current call:
1. Turn or press the Push/MENU/ TUNE knob.
2. Select Enter Number.
3. Enter the character sequence then select Call. See “Entering a Character Sequence” in Operation.
4. After the call has been placed, turn or press the Push/MENU/ TUNE knob and choose Merge Calls.
5. To add more callers to the conference call, repeat Steps 1 −4. The number of callers that can be added is limited by your wireless service carrier.
Call Waiting
Call waiting must be supported on the Bluetooth phone and enabled by the wireless
service carrier to work.
Accepting a Call
Turn the Push/MENU/TUNE knob to “Answer” and press the Push/ MENU/TU ...
Ending a Call
Turn or press the Push/MENU/ TUNE knob and select Hang Up. ...
Other materials:
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Transmission General Description
The Hydra-matic 6T30/40/45/50 is a fully automatic, 6-speed, front-wheel drive,
electronic-controlled transmission. It consists primarily of a 4-element torque
converter, a compound planetary gear set, friction and mechanical clutch assemblies,
and a hydraulic pressurization and control system ...
Transmission Mount Replacement - Left Side
Removal Procedure
Remove the battery tray. Refer to
Battery Tray Replacement.
Install the engine support fixture. Refer to
Engine Support Fixture.
Remove and DISCARD the left transmission mount to
bracket bolts (1).
Remove the left transmission mo ...
0.0081