Chevrolet Sonic Repair Manual: Control Solenoid Valve and Transmission Control Module Assembly Installation
|
Callout |
Component Name |
|---|---|
|
1 |
Control Solenoid Valve Assembly Filter Plate Caution: Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter plate to the control solenoid valve assembly, resulting in possible damage or contamination. Note: Install a NEW filter plate to prevent fluid leaks past the fluid seals. |
|
2 |
Control Solenoid (w/Body and TCM) Valve Assembly |
|
3 |
Control Valve Body Bolt M5 x 40.5 (Qty: 3) Caution: Refer to Fastener Caution.
7 Y (62 lb in) |
|
4 |
Control Valve Body Bolt M6 x 97 (Qty: 12) Tighten
10 Y (89 lb in) |
Control Solenoid Valve and Transmission Control Module Assembly Inspection
Verify the conditions listed below do not exist. Carefully
inspect the control solenoid valve assembly connectors and pins (1, 2, 4, 6)
for the condition. Repair or replace as neces ...
Control Solenoid Valve and Transmission Control Module Assembly Programming
and Setup (6T30/6T40/6T45/6T50)
The following service procedures require either a programming or a setup event
be performed for a complete repair. The transmission control module (TCM) is part
of the control solenoid valve ...
Other materials:
Instrument Panel Outer Trim Cover Replacement
Instrument Panel Outer Trim Cover Replacement
Callout
Component Name
1
Instrument Panel Outer Trim Cover (Qty:?€‰2)
Procedures
Use a flat bladed plastic trim tool in order to disengage the retainers
securi ...
Instrument Panel Lower Airbag Replacement - Passenger Side
Instrument Panel Lower Airbag Replacement - Passenger Side
Callout
Component Name
Warning: Refer to SIR Inflator Module Handling and Storage
Warning.
Warning: Refer to SIR Warning.
Preliminary Procedu ...
Thrust Washer and Bearing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Caution: Do not allow the bearings to spin. Turn them slowly by
hand. Spinning the beari ...
0.0059