Chevrolet Sonic Repair Manual: Control Valve Body Assembly Disassemble (Gen 2)
|
Callout |
Component Name |
|---|---|
|
1 |
Control Solenoid Valve Support |
|
2 |
Control Valve Body Bolt M5 x 40.5 (Qty: 1) |
|
3 |
Valve Channel Plate Note: Inspect the channel plate bolt pass through holes for damage or brinelling. Any damage will cause incorrect pressure switch operation. Replace as necessary. |
|
4 |
Valve Body Ball Check Valves (Qty: 6) |
Control Valve Body Assembly Disassemble (Gen 1)
Control Valve Body Assembly Disassemble
Callout
Component Name
1
Control Solenoid Valve Support
2
...
Control Valve Body Assembly Installation
Control Valve Body Assembly Installation
Callout
Component Name
1
Low and Reverse Clutch Fluid Passage Seal
...
Other materials:
Rear Brake Hose Replacement (Axle to Caliper)
Removal Procedure
Warning: Refer to Brake Dust Warning.
Warning: Refer to Brake Fluid Irritant Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Install ...
HVAC System Control Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the control module is not properly configured
with the correct calibration software, the control module will not control
all of the vehicle features properly.
Ensure th ...
Oil Pan Installation
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces from old sealing material, dirt, oil and grease.
Note: The sealing bead should be applied close to the inner edge
of the oil pan. Take care that the oil suctio ...
0.0044