Chevrolet Sonic Repair Manual: Crankshaft Front Oil Seal Installation
Special Tools
EN-6351 Mounting Sleeves
For equivalent regional tools, refer to Special Tools.
- Clean the sealing surfaces.
- Slide the EN-6351 sleeves (2) protective sleeve onto the crankshaft journal.
- Slide the crankshaft front oil seal (1) over the protective sleeve on the crankshaft journal.
- Remove the protective sleeve, and using the EN-6351 sleeves (3), press the seal ring into the pump housing.
- Use the crankshaft drive gear bolt (1) and washer (2) to press in the crankshaft front oil seal.
Camshaft Seal Replacement
Special Tools
EN 422 Installer
EN 45000 Remover
For equivalent regional tools, refer to Special Tools
Removal Procedure
Remove the intake and exhaust camshaft sprocket. Refer t ...
Crankshaft Front Oil Seal Replacement
Special Tools
EN-960 Installer
EN-45000 Remover Oil seal
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the crankshaft balancer. Refer to Crank ...
Other materials:
Fabric/Carpet/Suede
Start by vacuuming the surface using a soft brush attachment. If a rotating brush
attachment is being used during vacuuming, only use it on the floor carpet. Before
cleaning, gently remove as much of the soil as possible using one of the following
techniques:
Gently blot liquids with a pap ...
Replacement Wheels Description
Replace the wheel if any of the following conditions exist:
The wheel exhibits excessive runout.
The wheel is bent.
The wheel is cracked.
The wheel is severely rusted.
The wheel is severely corroded.
Note: Air leaks caused by porosity on aluminum wheels are repairable.
...
Engine Component Description
Cylinder Block
The cylinder hollow frame structured in–line 4 cylinder. The block has 5 crankshaft
bearings with the thrust bearing located on the third bearing from the front
of the engine.
Crankshaft
The crankshaft is a steel crankshaft. It is supported ...
0.0069