Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Crankshaft Front Oil Seal Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / Engine Block / Seals and Gaskets / Crankshaft Front Oil Seal Replacement

Special Tools

For equivalent regional tools, refer to Special Tools.

Removal Procedure
  1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement.
  2. Place a drain pan underneath the front crankshaft seal area.

  3. Remove crankshaft front oil seal (2) from engine front cover. Use EN-45000 remover  (1).
Installation Procedure

    Install NEW crankshaft front oil seal (1) to EN-960 installer
  1. Install NEW crankshaft front oil seal (1) to EN-960 installer  (2).


  2. Install crankshaft front oil seal by means of EN-960 installer  (1) to engine front cover (2).


  3. Ensure that crankshaft front oil seal (2) is flush with engine front cover (1).
  4. Install crankshaft balancer. Refer to Crankshaft Balancer Replacement.
  5. Remove the drain pan.
  6. Check and correct engine oil level.
Crankshaft Front Oil Seal Installation
Special Tools EN-6351 Mounting Sleeves For equivalent regional tools, refer to Special Tools. Clean the sealing surfaces. Slide the EN-6351 sleeves  (2) protective sleeve onto t ...

Crankshaft Rear Oil Seal Installation
Special Tools EN-658-1 Installer EN-235-6 Installer For equivalent regional tools, refer to Special Tools. Slide the crankshaft rear oil seal (2) across the EN-235-6 installe ...

Other materials:

Automatic Transmission
Move the shift lever to P (Park) or N (Neutral). The engine will not start in any other position. To restart the engine when the vehicle is already moving, use N (Neutral) only. Caution Do not try to shift to P (Park) if the vehicle is moving. If you do, you could damage the transmission. Sh ...

Front Seat Back Recliner Handle Replacement
Front Seat Back Recliner Handle Replacement Callout Component Name 1 Front Seat Recliner Handle Cover Cap Procedure Use a flat-bladed tool to release the handle cover from the handle assembly. ...

Engine Oil Cooler Replacement
Removal Procedure Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Drain engine coolant. Refer to Cooling System Draining and Filling Remove the turbocharger oil feed pipe. Refer to Turbocharger Oil Feed Pipe Replacement ...

В© 2014-2025 Copyright www.csmans.com
 
0.0057