Chevrolet Sonic Repair Manual: Crankshaft Position System Variation Learn

Chevrolet Sonic Repair Manual / Powertrain / Engine / Engine Block / Cylinder Block / Crankshaft Position System Variation Learn

Note:

The crankshaft position sensor system variation learn procedure is required when the following service procedures have been performed, regardless of whether DTC P0315 is set:

Engine replacement
Engine control module (ECM) replacement
Crankshaft damper replacement
Crankshaft replacement
Crankshaft Position Sensor Replacement
Any engine repairs which disturb the crankshaft to crankshaft position sensor relationship

Note:

The ECM monitors certain component signals to determine if all the conditions are met to continue with the Crankshaft Position Variation Learn procedure.

Ignition ON, observe the DTC information with a scan tool. Verify no other DTCs are set, except DTCs P0300–P0304, or P0315.

If DTCs are set, except DTCs P0300–P0304, or P0315, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.

Select the Crankshaft Position Variation Learn Procedure with a scan tool and follow the on screen instructions:

Verify DTC P0315 does not set.

If DTC P0315 set, or another DTC is present refer to Diagnostic Trouble Code (DTC) List - Vehicle for the applicable DTC that set.

If the DTC does not set

All OK.

Crankshaft Balancer Replacement

Special Tools EN-470–B Angular Torque Wrench EN-49979 Crankshaft Shock Mount Retainer For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suppo ...

Crankshaft and Bearing Cleaning and Inspection

Special Tools EN-45059 Torque Angle Sensor Kit GE-571-B Dial Gauge For equivalent regional tools, refer to Special Tools. Crankshaft End Play, Check Note: Cranksha ...

Other materials:

Front Bumper Fascia Opening Lower Cover Replacement
Front Bumper Fascia Opening Lower Cover Replacement Callout Component Name 1 Front Bumper Fascia Opening Lower Cover Push-In Retainer 2 Front Bumper Fascia Opening Lower Cover Bolt (Qty:?€� ...

Fuel Tank Fuel Pump Module Replacement (Steel Tank)
Special Tools EN-48279 Fuel Sender Lock Ring Wrench For equivalent regional tools, refer to Special Tools. Removal Procedure Relieve the fuel system pressure. Refer to Fuel Pressure Relief. Remove the fuel tank. Refer to Fuel Tank Replacement. Disconnect the ...

Torque Converter Fluid Seal Replacement
Torque Converter Fluid Seal Replacement Callout Component Name 1 Torque Converter Fluid Seal Retainer 2 Torque Converter Fluid Seal Special Tools DT-47791-A Seal Installer DT-6125- ...

0.006