Chevrolet Sonic Repair Manual: Cylinder Head Removal
- Loosen the 12 cylinder head bolts in the sequence as shown. Use the following procedure:
- Loosen the cylinder head bolts 90 degrees.
- Loosen the cylinder head bolts 180 degrees.
- Remove the 12 cylinder head bolts (1).
- Remove the cylinder head (2).
- Remove the cylinder head gasket (3).
Note:
Do not damage the guide sleeves (4) and (5).
Cylinder Head Installation
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Inspect for plane surface.
Cylinder block, cylinder h ...
Cylinder Head Replacement
Special Tools
BO-38185 Hose Clamp Pliers
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Disconnect the negative battery cable. Re ...
Other materials:
Remote Vehicle Speed Limiting Description and Operation
Certain vehicles equipped with OnStar® now have an additional feature that allows
for remote limiting of the vehicle's speed. This OnStar® feature is called Stolen
Vehicle Slow-Down and is now part of the OnStar® Stolen Vehicle Assistance service.
This feature, when used in conjunction ...
Theft Deterrent Module Replacement
Theft Deterrent Module Replacement
Callout
Component Name
Preliminary Procedure
Remove the steering column upper trim cover. Refer
to Steering Column Upper Trim Cover Replacement.
Remove the steering column lower trim ...
Drivetrain and Front Suspension Frame Skid Plate Replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the mounting bolts (1) for the front suspension frame skid plate.
Remove the front suspension frame skid plate (2).
Installation Procedure ...
0.0069