DRL can make it easier for others to see the front of your vehicle during the day. Fully functional DRL are required on all vehicles first sold in Canada.

This indicator light turns on in the instrument cluster when the DRL are on.
A light sensor on top of the instrument panel makes the DRL work, so be sure it is not covered.
The DRL system makes the low-beam headlamps come on at a reduced brightness when the following conditions are met:
When the DRL are on, only the low-beam headlamps, at a reduced level of brightness, will be on. The taillamps, sidemarker, instrument panel, and other lamps will not be on.
The headlamps automatically change from DRL to the regular headlamps depending on the darkness of the surroundings. The other lamps that come on with the headlamps will also come on.
When it is bright enough outside, the headlamps go off and the DRL come on.
To turn the DRL lamps off or on again, turn the exterior lamp control to
and then release. For vehicles first
sold in Canada, the DRL lamps cannot be turned off.
Flash-to-Pass
Automatic Headlamp SystemFront Side Door Check Link Replacement
iii!
Front Side Door Check Link Replacement
Callout
Component Name
Preliminary Procedure
Remove the front side door trim panel. Refer to Front Side Door Trim
Replacement.
1
Front Side Door Check ...
Crankshaft and Bearing Cleaning and Inspection
Special Tools
EN-45059 Torque Angle Sensor Kit
GE-571-B Dial Gauge
For equivalent regional tools, refer to Special Tools.
Crankshaft End Play, Check
Note: Crankshaft attached with crankshaft bearing caps.
Install the GE-571-B gauge (1).
...
Spark Plug Replacement
Spark Plug Replacement
Callout
Component Name
Preliminary Procedure
Open the hood.
Remove the engine sight shield.
Remove the ignition coil. Refer to Ignition Coil Replacement.
1
Spark P ...