Chevrolet Sonic Owner's Manual: Disarming the System
To disarm the system, either unlock the doors using the RKE transmitter, or start the vehicle with a recognized transmitter in the vehicle.
To avoid setting off the alarm by accident:
- Press
on the RKE transmitter. - Start the vehicle.
To avoid setting off the alarm by accident:
- Lock the vehicle after all occupants have left the vehicle and all doors are closed.
- Always unlock a door with the RKE transmitter.
Unlocking the driver door with the key will not disarm the system or turn off the alarm.
Arming the AlarmSystem
1. Close all doors, the trunk/liftgate, and the hood.
2. Lock the vehicle in one of two ways:
Use the RKE transmitter.
With a door open, press on the
interior of the door.
3. After 30 se ...
How to Detect a Tamper Condition
If is pressed on the transmitter
and the horn chirps three times, an alarm occurred previously while the alarm system
was armed. ...
Other materials:
Hydraulic Brake System Bleeding (Manual)
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components
Caution.
Caution: Only use products that comply with GM specifications and
check manufacturer information respectively. We recommend the use of GM genuine
...
Brake Pedal Position Sensor Replacement
Removal Procedure
Remove the instrument panel lower trim pad cover. Refer to Instrument
Panel Lower Trim Pad Cover Replacement.
Disconnect the brake pedal position sensor electrical connector.
Remove the brake pedal position sensor bolt (1).
Remove t ...
Power Steering Control Module Programming and Setup
The following service procedures require either a programming or a setup event
performed for a complete repair.
Power Steering Control Module Replacement
If the steering column power steering control module needs to be is replaced,
the power steering control module needs to be progra ...
0.006