Chevrolet Sonic Repair Manual: Door Lock and Ignition Lock Folding Key Blade Removal and Installation

Chevrolet Sonic Repair Manual / Accessories / Security & Keyless Entry / Locks / Door Lock and Ignition Lock Folding Key Blade Removal and Installation

Special Tools

BO-51098 Flip Key Blade Fixture

For equivalent region tools, refer to Special Tools.

Caution:

Failure to properly support the Remote Keyless Entry (RKE) transmitter assembly while replacing the key blade may cause internal damage to the transmitter assembly.

Insert the RKE transmitter in the fixture as shown.

Note:

It may be necessary to dress the pin drift on a grinder to maintain the diameter in order to drive the pin through the housing.

Using the BO-51098 fixture, drive the retention pin from the transmitter assembly as shown.

Remove the key blade from the transmitter assembly.
Install the coded blank into the transmitter assembly, insure the indentation on the key blade faces the retention pin.

Note:

Use caution not to damage the surface, chrome plating, in the following steps.

Using needle nose pliers, insert the pin half way into the transmitter assembly.

Using the BO-51098 fixture, drive the roll pin flush to the surface.

Door Lock Switch Replacement

Door Lock Switch Replacement Callout Component Name Preliminary Procedure Remove the heater and air conditioning control. Refer ...

Door Lock and Ignition Lock Folding and Non-Folding Key Cutting

High Security keys are available from the service parts system. Obtain the key code from the security card or from the GM Dealer World, Parts, Key Code Look Up system. If you have the key code a ...

Other materials:

Traction Off Light
This light comes on briefly while starting the engine. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indicator light then turns off. The traction off light comes on when the Traction Control System (TCS) has been turned off by pressing and ...

Home Page (Radio with Touchscreen)
Touchscreen Buttons Touchscreen buttons show on the screen when available. When a function is unavailable, the button may gray out. When a function is selected, the button may highlight. Home Page Features audiopicturemovietelephoneelsmartphonelinksettings03/06/2012 ...

Instrument Panel Center Molding Replacement (With U58)
Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90 ...

0.0102