Chevrolet Sonic Repair Manual: Drive and Driven Sprocket, Drive Link, and Park Pawl Installation (6T30)

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Drive and Driven Sprocket, Drive Link, and Park Pawl Installation (6T30)

Drive and Driven Sprocket, Drive Link, and Park Pawl Installation
Callout	Component Name
1	Front Differential Carrier Baffle
2	Baffle Retainer
3	Front Differential Carrier Baffle Bolt M6 x 16 (Qty: 2) Caution: Refer to Fastener Caution. Tighten 12 Y (106 lb in)
4	Drive Link Lube Scoop Seal
5	Drive Link Lube Fluid Seal
6	Drive Link Lube Scoop
7	Driven Sprocket Bearing Assembly
8	Drive Sprocket Bearing Assembly
9	Driven Sprocket Assembly, Drive Sprocket Assembly and Drive Link Note: Install the drive link with the colored links and/or part number facing up. The drive link, drive, and driven sprocket assemblies must be installed at the same time. The ball bearing should spin freely and smoothly. The driven sprocket ball bearing inner race has a slight interference fit with the case. Tap gently with the palm of a hand or a soft tip hammer to install.
10	Park Pawl
11	Park Pawl Spring
12	Park Pawl Shaft Note: Check to ensure that the park pawl operates freely and is not binding.

Drive Sprocket, Driven Sprocket, and Drive Link Cleaning and Inspection

Drive Sprocket, Driven Sprocket, and Drive Link Cleaning and Inspection Callout Component Name 1 Drive Sprocket Thrust W ...

Drive and Driven Sprocket, Drive Link, and Park Pawl Installation (6T40/45/50)

Drive and Driven Sprocket, Drive Link, and Park Pawl Installation Callout Component Name 1 Front Differential Carrier Ba ...

Other materials:

Front Floor Console Cup Holder Replacement
Front Floor Console Cup Holder Replacement Callout Component Name Preliminary Procedure Remove the front floor console assembly. Refer to Front Floor Console Replacement. 1 Front Floor Console C ...

Camshaft Timing Chain Installation
Special Tools EN-952 Fixing Pin EN-953-A Fixing Tool EN-955-10 Fixing Pin from EN-955 Kit For equivalent regional tools, refer to Special Tools. The engine should be adjusted to TDC. The crankshaft should be locked with EN-952 fixing pin. The camshaft should be locked with EN-9 ...

Torque Converter Housing with Fluid Pump Assembly Removal (Non Hybrid)
Torque Converter Housing with Fluid Pump Assembly Removal Callout Component Name 1 Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 15) 2 Torque Conv ...

0.0053