Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Drive and Driven Sprocket, Drive Link, and Park Pawl Removal (6T40/45/50)

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Drive and Driven Sprocket, Drive Link, and Park Pawl Removal (6T40/45/50)



Drive and Driven Sprocket, Drive Link, and Park Pawl Removal

Callout

Component Name

1

Drive Link Lube Scoop

2

Drive Link Lube Scoop Seals

3

Drive Link Lube Fluid Seal

4

Driven Sprocket Assembly, Drive Sprocket and Park Gear Assembly and Drive Link

Procedure

  1. The drive link, drive and driven sprocket assemblies must be removed at the same time.
  2. The driven sprocket ball bearing inner race has a slight interference fit with the case. Pull straight up to ease removal.

5

Driven Sprocket Bearing Assembly

Note:

The driven sprocket bearing may be stuck to the driven sprocket.

6

Front Differential Carrier Baffle Bolts M6 x 16 (Qty: 2)

7

Front Differential Carrier Baffle

8

Park Pawl Shaft

9

Park Pawl Spring

10

Park Pawl

Drive and Driven Sprocket, Drive Link, and Park Pawl Removal (6T30)
Drive and Driven Sprocket, Drive Link, and Park Pawl Removal Callout Component Name 1 Drive Link Lube Scoop ...

Electronic Component Description
Control Solenoid Valve Assembly (1) Pressure Control Solenoid 3 (R-1/4-5-6) (2) (GEN 1) Pressure Control Solenoid 2 (3-5-R) ...

Other materials:

Starting the Vehicle
1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold for at least four seconds or until the turn signal lamps flash. When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The ...

Rear Side Door Trim Replacement (Sedan)
Rear Side Door Trim Replacement Callout Component Name 1 Rear Side Door Inside Handle Bolt Cap 2 Rear Side Door Inside Handle Fastener Caution: Refer to Fastener Caution. Proce ...

SIR Service Precautions
General Service Instructions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, person ...

В© 2014-2026 Copyright www.csmans.com
 
0.0062