Chevrolet Sonic Repair Manual: Drive Belt Installation
Special Tools
- EN-955 Locking Pins
- EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
- Install the drive belt.
- Move the drive belt tensioner clockwise until EN-955?E0 locking pin (2) can be removed. Use EN-48488 wrench (1).
- Remove EN-955?E0 locking pin (2) from the drive belt tensioner while holding with EN-48488 wrench (1).
- Release tension from drive belt tensioner and remove EN-48488 wrench (1).
Note:
Ensure that the drive belt tensioner is held with EN-955?E locking pin.
Drive Belt Tensioner Replacement
Special Tools
EN-955 Locking Pin
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the right front wheelhouse liner extens ...
Drive Belt Removal
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Install EN-48488 wrench (1) to the drive belt tensioner.
...
Other materials:
Hood Rear Weatherstrip Replacement
in
Hood Rear Weatherstrip Replacement
Callout
Component Name
1
Hood Rear Weatherstrip
Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers
that are part of the air inlet grille. ...
Instrument Panel Center Trim Panel Replacement
Instrument Panel Center Trim Panel Replacement
Callout
Component Name
1
Instrument Panel Center Trim Panel (Qty:?€‰2)
Procedure
Use a flat bladed plastic trim tool in order to disengage the retainers
secur ...
Front Wheel Drive Intermediate Shaft Replacement
Front Wheel Drive Intermediate Shaft Replacement
Callout
Component Name
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the wheel drive shaft assembly from the vehicle ...
0.0068