Chevrolet Sonic Repair Manual: Drive Belt Removal
Special Tools
- EN-955 Locking Pins
- EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
- Install EN-48488 wrench (1) to the drive belt tensioner.
- Move the drive belt tensioner clockwise until the drive belt tensioner can be fixed with the EN-955?E0 locking pin (2).
- Remove the drive belt.
Note:
The drive belt tensioner must always be in a pre-tensioned state.
Drive Belt Installation
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Note: Ensure that the drive belt tensioner is held with EN-955?E
...
Drive Belt Replacement
Special Tools
EN-48488 Holding Wrench
EN-955 Locking Pin
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the right front wheelhouse liner extens ...
Other materials:
General Information
Your vehicle is an important investment. This section describes the required
maintenance for the vehicle. Follow this schedule to help protect against major
repair expenses resulting from neglect or inadequate maintenance. It may also help
to maintain the value of the vehicle if it is sold. It ...
General Description
The factory installed tires are designed to operate satisfactorily with loads
up to and including the full rated load capacity when these tires are inflated to
the recommended pressures.
The following factors have an important influence on tire life:
Correct tire pressures
Correct wheel ...
Battery Charging
Special Tools
EL 50313 Battery Tester
For equivalent regional tools, refer to Special Tools.
Diagnostic Aids
For best results, use an automatic taper-rate battery charger with a
voltage capability of 16 V.
The charging area should be well ventilated.
Do not charge a bat ...
0.0581