Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Driver or Passenger Seat Back Cushion Frame Replacement

Chevrolet Sonic Repair Manual / Body / Seating / Seats / Information / Driver or Passenger Seat Back Cushion Frame Replacement



Driver or Passenger Seat Back Cushion Frame Replacement

Callout

Component Name

Preliminary Procedures

  1. Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation
  2. Remove the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement
  3. Remove the front seat cushion inner recliner. Refer to Front Seat Cushion Inner Trim Panel Replacement

1

Front Seat Back Cushion Frame Bolt (Qty:?€‰4)

Caution:

Refer to Fastener Caution.

Tighten


22?€‰Y(16?€‰lb?€‰ft)

2

Driver or Passenger Seat Back Cushion Frame

Procedure

  1. Disconnect electrical connectors as needed.
  2. If replacing with a new front seat back cushion frame, transfer components as necessary.
Driver or Passenger Seat Back Cover and Pad Replacement
Driver or Passenger Seat Back Cover and Pad Replacement Callout Component Name Warning: Refer to SIR Warning. War ...

Driver or Passenger Seat Back Cushion Heater Replacement
Driver or Passenger Seat Back Cushion Heater Replacement Callout Component Name Warning: Refer to SIR Warning. Prelimi ...

Other materials:

Safety Locks
The rear door safety locks prevent passengers from opening the rear doors from inside the vehicle. Manual Safety Locks If equipped, the safety lock is located on the inside edge of the rear doors. To use the safety lock: 1. Insert the key into the safety lock slot and turn it so the slot is ...

Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. See Engine Compartment Overview for the location of the reservoir. There are only two reasons why the fluid level in the reservoir might go down: The fluid level goes down b ...

Crankshaft Front Oil Seal Replacement
Special Tools EN-960 Installer EN-45000 Remover Oil seal For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement. Place a drain pan underneath the front crankshaft seal area. ...

© 2014-2026 Copyright www.csmans.com
 
0.0089