Chevrolet Sonic Repair Manual: Driver or Passenger Seat Shoulder Belt Replacement (with A69)

Chevrolet Sonic Repair Manual / Body / Restraints / Restraints Control / Driver or Passenger Seat Shoulder Belt Replacement (with A69)

Driver or Passenger Seat Shoulder Belt Replacement
Callout	Component Name
Warning: Refer to SIR Warning. Warning: Refer to SIR Inflator Module Handling and Storage Warning. Warning: Refer to SIR Seatbelt Pretensioner Handling Warning. Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws. Preliminary Procedures Move the front seat to a full forward and full up position. Disable the SIR. Refer to SIR Disabling and Enabling. Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement.
1	Driver or Passenger Seat Belt Tensioner Cover
2	Driver or Passenger Seat Belt Tensioner Cover Fastener Caution: Refer to Fastener Caution. Tighten 7.5?€‰Y (66?€‰lb?€‰in)
3	Driver or Passenger Seat Belt Tensioner Cover
4	Driver or Passenger Seat Shoulder Belt Fastener Tighten 45?€‰Y (33?€‰lb?€‰ft)
5	Driver or Passenger Shoulder Belt Retractor Fastener Tighten 45?€‰Y (33?€‰lb?€‰ft) Note: When the seat belt retractor is replaced with a new one, there is no thread in the nut welded to the retractor. This is normal as the bolt will make the thread in the welded nut when the bolt is tightened.
6	Driver or Passenger Seat Belt Push On Retainer Procedure Use a flat-bladed tool to remove locking pin in retainer.
7	Driver or Passenger Seat Shoulder Belt Retractor Assembly Procedure Disconnect the electrical connector. Refer to Pretensioner Handling and Scrapping.

Airbag Steering Wheel Module Replacement

Removal Procedure Warning: Refer to SIR Inflator Module Handling and Storage Warning. Warning: Refer to SIR Warning. Disable the SIR system. Refer t ...

Driver or Passenger Seat Shoulder Belt Replacement (without A69)

Driver or Passenger Seat Shoulder Belt Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: ...

Other materials:

Parking Brake Adjustment (Disc Brake)
Note: The park brake cable adjusting nut is a nylon lock type. Use ONLY HAND TOOLS whenever tightening or loosening the adjusting nut. Apply and fully release the park brake several times. Verify that the park brake lever releases completely. Turn ON the ignition. Verify the red B ...

Input Speed Sensor Replacement
Removal Procedure Remove the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement. Remove the input speed sensor bolt (2) M6 x 23. Unlock t ...

Throttle Body Assembly Installation
Install a NEW throttle body seal. Install the throttle body (1). Caution: Refer to Fastener Caution. Install the 4 throttle body bolts (2) and tighten to 8 Y (71 lb in). ...

0.006