Chevrolet Sonic Owner's Manual: Driving and Operating
- Driving Information
- Distracted Driving
- Defensive Driving
- Drunk Driving
- Control of a Vehicle
- Braking
- Steering
- Off-Road Recovery
- Loss of Control
- Driving on Wet Roads
- Highway Hypnosis
- Hill and Mountain Roads
- Winter Driving
- If the Vehicle Is Stuck
- Vehicle Load Limits
- Starting and Operating
- New Vehicle Break-In
- Ignition Positions
- Starting the Engine
- Engine Heater
- Retained Accessory Power (RAP)
- Shifting Into Park (Automatic Transmission)
- Shifting out of Park (Automatic Transmission)
- Parking
- Parking over Things That Burn
- Engine Exhaust
- Automatic Transmission
- Manual Transmission
- Brakes
- Ride Control Systems
- Cruise Control
- Driver Assistance Systems
- Fuel
- Fuel
- Recommended Fuel
- Gasoline Specifications
- California Fuel Requirements
- Fuels in Foreign Countries
- Fuel Additives
- Filling the Tank
- Filling a Portable Fuel Container
- Trailer Towing
- Conversions and Add-Ons
Maintenance
Air Intake
Clear away any ice, snow, or leaves from the air intake at the base of the windshield
that can block the flow of air into the vehicle.
Passenger Compartment Air Filter
The filter remov ...
Other materials:
Trunk Release
To lock or unlock the trunk from the inside, press
or
on the central locking switch or on
the driver door switch.
To open the trunk from inside the vehicle press
.
To lock the trunk from the outside press
on the RKE transmitter.
To open the trunk from outside of the vehicle:
Pres ...
Charging System Description and Operation
Electrical Power Management Overview
The electrical power management system is designed to monitor and control
the charging system and send diagnostic messages to alert the driver of possible
problems with the battery and generator. This electrical power management system
primarily ...
Intake Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...
0.0075