Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Eliminating Unwanted Odors in Vehicles

Chevrolet Sonic Repair Manual / Body / General / Eliminating Unwanted Odors in Vehicles

GM Vehicle Care Odor Eliminator, Refer to Adhesives, Fluids, Lubricants, and Sealers, may control or eliminate odors in the interior and luggage compartment areas of GM vehicles. This non-toxic, biodegradable, odorless product has been shown to greatly reduce or remove the following types of odor:

You may safely use GM Vehicle Care Odor Eliminator on fabrics, vinyl, leather, carpet, and sound deadening materials. You may also induce this product into HVAC modules and instrument panel ducts for the control of non-bacterial related odors.

Note:

This product leaves no residual scent and should not be used as an air freshener.

This product may result in the permanent elimination of an odor and may be preferable to customers whose allergies make them sensitive to perfumes. This product may effectively remove odors when directly contacting the odor source. In cases such as water leaks, use this product with diagnostic procedures to first eliminate the primary cause of the odor. Then use further applications on the residual odor to permanently correct the vehicle condition.

How to Use this Product

Dimensions - Body (5HB)
Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements are duplicated with ...

Front Hinge Pillar Body Sectioning
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Warning: Refer to Collision Sectioning Warning. Warning: Refer to ...

Other materials:

Water Pump Installation
Clean the sealing surfaces and the 3 coolant pump threads. Install NEW gasket. Caution: Refer to Fastener Caution. Caution: Refer to Torque-to-Yield Fastener Caution. Install the coolant pump (1). Install 5 NEW bolts (2) and tighten to 8& ...

Exhaust Heat Shield Replacement
Exhaust Heat Shield Replacement Callout Component Name Preliminary Procedure Disconnect the exhaust system hangers and allow the exhaust system to rest on the rear axle. 1 Exhaust Heat Shield Fa ...

Intake Manifold Removal (1.8L LUW and LWE)
Remove the 2 intake manifold brace bolts (2, 3). Remove the intake manifold brace (1). Remove the 7 intake manifold bolts (1). Remove the intake manifold (2) and the 4 intake manifold gaskets. ...

В© 2014-2024 Copyright www.csmans.com
 
0.0085