Wheel Drive Shafts Description and Operation
GeneralTire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange,
remeasure the tire and wheel assembly on-vehicle runout in order to verify that
the amount of runout has been reduced and brought to within tolerances.
Mark the location of the high spot on the tire and wheel asse ...
Wheel Drive Shaft Outer Joint Inspection
Disassembly Procedure
Remove the outer constant velocity (CV) joint and boot from the wheel
drive shaft. Refer to Front Wheel Drive Shaft Outer Joint and Boot Replacement.
Remove any lubricant from the CV joint.
Note: Position the cage and the inner race so they a ...
2-6 Clutch Piston Installation (6T30)
2-6 Clutch Piston Installation
Callout
Component Name
1
2?E Clutch Piston Assembly
Note:
Position the 2?E piston air bleed and large slot toward the
top of the case.
DT-48271 seal protector ...