Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Engine Block Assemble


    Install the 4 piston oil nozzles (1).
  1. Install the 4 piston oil nozzles (1).
  2. Caution:

    Refer to Fastener Caution.

  3. Install the 4 piston oil nozzle bolts (2) and tighten to  25 Y (18 lb ft)

    .



  4. Install the knock sensor (2).
  5. Install the knock sensor bolt (3) and tighten to  20 Y (15 lb ft)

    .

  6. Install the 2 cylinder head guide sleeves (1). Use a rubber mallet.
  7. Install the 2 transmission guide sleeves (4) and (5). Use a rubber mallet.
Engine Block Procedures
...

Engine Block Disassemble
Remove the cylinder head locating (1, 2). Remove the oil pressure switch (1). Remove the knock sensor bolt (2) and the knock sensor (1). Clea ...

Other materials:

Buying New Tires
GM has developed and matched specific tires for the vehicle. The original equipment tires installed were designed to meet General Motors Tire Performance Criteria Specification (TPC Spec) system rating. When replacement tires are needed, GM strongly recommends buying tires with the same TPC Sp ...

Body Hinge Pillar Lower Reinforcement Replacement
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Disable the SIR system. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all ...

Drive Range, Second Gear (Gen 2)
As vehicle speed increases and operating conditions become appropriate, the transmission control module (TCM) processes input signals from the automatic transmission input and output speed sensors, the throttle position sensor and other vehicle sensors to determine the precise moment to comman ...

В© 2014-2025 Copyright www.csmans.com
 
0.0081