|
Callout |
Component Name |
|---|---|
|
Preliminary Procedures
Drain the cooling system. Refer to Cooling System Draining and Filling. |
|
|
1 |
Retaining Clamp |
|
2 |
Engine Coolant Temperature Sensor Procedure
Disconnect the electrical connector. |
Radiator
Radiator Air Baffle Replacement (LUV, LUW)Exterior Lighting
The exterior lamp control is on the instrument panel to the outboard side of
the steering column.
O : Briefly turn to this position to turn the automatic light control off or
on again.
AUTO: Turns the headlamps on automatically at normal brightness, together with
the following:
Parking ...
Exhaust Camshaft Installation
Note: Mind the markings on the camshaft bearing caps. Camshaft
bearing caps should be installed in their original position.
Lubricate camshaft and camshaft bearing caps with engine oil.
Install the exhaust camshaft (3).
Install the 5 camshaft bearing caps̴ ...
Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl
Actuator Removal
Table 1:
Manual Shaft Detent (w/Shift Position Switch) Lever
Assembly Removal
Table 2:
Park Pawl Actuator Guide Removal
Manual Shaft Detent (w/Shift Position
Switch) Lever Assembly Removal
Manual Shaft Detent (w/Shift Position Switch) Lever Assemb ...