|
Callout |
Component Name |
|---|---|
|
Preliminary Procedures
Drain the cooling system. Refer to Cooling System Draining and Filling. |
|
|
1 |
Retaining Clamp |
|
2 |
Engine Coolant Temperature Sensor Procedure
Disconnect the electrical connector. |
Crankshaft Position Sensor Replacement
Engine Coolant Temperature Sensor Replacement (Water Outlet)Stabilizer Shaft Replacement
Removal Procedure
Remove the intermediate steering shaft lower bolt. Refer to Intermediate
Steering Shaft Replacement.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Inst ...
Throttle Body Assembly Installation
Install a NEW throttle body seal.
Install the throttle body (1).
Caution: Refer to Fastener Caution.
Install the 4 throttle body bolts (2) and tighten to 8 Y (71 lb in).
...
Air Intake System Description
Circuit/System Description
The primary function of the air intake system is to provide filtered air
to the engine. The system uses a filter element mounted in a housing. The filter
housing is remotely mounted and uses intake ducts to route the incoming air
into the throttle body. T ...