Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Engine Coolant Temperature Sensor Replacement (Water Outlet)

Chevrolet Sonic Repair Manual / Powertrain / Internal Combustion Powertrain Control / Engine Control / Engine Control Sensors / Engine Coolant Temperature Sensor Replacement (Water Outlet)



Engine Coolant Temperature Sensor Replacement

Callout

Component Name

Preliminary Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Drain the cooling system. Refer to Cooling System Draining and Filling.

1

Engine Coolant Temperature Sensor Fastener

2

Engine Coolant Temperature Sensor

Procedure

Disconnect the electrical wiring harness connector from the engine coolant temperature sensor.

Engine Coolant Temperature Sensor Replacement (Radiator)
Engine Coolant Temperature Sensor Replacement - Radiator Callout Component Name Preliminary Procedures Drain the cooling system ...

Engine Coolant Temperature Sensor Replacement - Radiator
Engine Coolant Temperature Sensor Replacement - Radiator Callout Component Name Preliminary Procedure Drain the cooling system. Ref ...

Other materials:

Collision Damage Repair
If the vehicle is involved in a collision and it is damaged, have the damage repaired by a qualified technician using the proper equipment and quality replacement parts. Poorly performed collision repairs diminish the vehicle resale value, and safety performance can be compromised in subsequen ...

Dimensions - Body (4NB)
Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements are duplicated with tram bar pointers set at equal lengths. All die marks, holes, slots, and fasteners are measured t ...

Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution. The part and vehicle surface should be 21?°C (70?°F) prior to installation. The vehicle should remain inside in a temperature range of 21?°C (70?°F) for 1 hour after assembly to allow the adhesive to develop sufficient bo ...

© 2014-2025 Copyright www.csmans.com
 
0.007