Chevrolet Sonic Repair Manual: Engine Coolant Thermostat Installation

Engine Coolant Thermostat Housing Replacement (LUW)

Removal Procedure Remove the battery tray. Refer to Battery Tray Replacement. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Drain the cooling system. ...

Engine Coolant Thermostat Removal

Caution: Refer to Engine Coolant Thermostat Housing Caution. Remove the 4 engine coolant thermostat bolts (3). Remove the engine coolant thermostat assembly  ...

Other materials:

Key with Integrated Transmitter Programming
Keys can be programming in various ways using the procedures outlined below. Using the Replacing Keys procedures will first erase all the known keys from the vehicle. Any existing keys and any new keys will then be programmed. This procedure should be used any time a key is required to be unle ...

Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange, remeasure the tire and wheel assembly on-vehicle runout in order to verify that the amount of runout has been reduced and brought to within tolerances. Mark the location of the high spot on the tire and wheel asse ...

Clutch and Differential Housing Assemble
Special Tools R-0007761 Universal Handle for Pullers and Installers R-0407009 Countershaft Front Bearing Driver R-0407010 Input Shaft Needle Bearing Puller and Driver R-0407014 Gearshift Device Bushing Driver ?#8201;Use with R-0007761 S-9707500 Axle Shaft Seal Installer For ...