Chevrolet Sonic Owner's Manual: Engine Oil Change
When a 
%CHANGE message displays
in the DIC, have the engine oil and filter changed within the next 1 000 km/600
mi. If driven under the best conditions, the engine oil life system might not indicate
the need for vehicle service for more than a year. The engine oil and filter must
be changed at least once a year and the oil life system must be reset. Your trained
dealer technician can perform this work. If the engine oil life system is reset
accidentally, service the vehicle within 5 000 km/ 3,000 mi since the last service.
Reset the oil life system when the oil is changed. See Engine Oil Life System.
Owner Checks and Services
At Each Fuel Stop
Check the engine oil level. See Engine Oil.
Once a Month
Check the tire inflation pressures. See Tire Pressure.
Inspect the tires for wear. See Tire Inspection.
Check ...
Tire Rotation and Required Services Every 12 000 km/ 7,500 mi
Rotate the tires, if recommended for the vehicle, and perform the following services.
See Tire Rotation.
Check engine oil level and oil life percentage. If needed, change engine
oil and filte ...
Other materials:
Sunroof Window Seal Replacement
Removal Procedure
Remove the sunroof window panel. Refer to Sunroof Window Replacement.
Remove the seal from the window panel frame by pulling the seal away
at one point and continuing around the perimeter of the frame.
Clean around the edge of the inside surf ...
Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral
(N) position, the transmission will provide engine braking. In this operating range,
the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine
braking mode, the following changes occur with ...
Clutch and Differential Housing Disassemble
Special Tools
M-680770 Universal Sliding Mallet
R-0007758 Holding Fixture
R-0407008 Counter Shaft Bearing Remover
R-0407010 Input Shaft Needle Bearing Puller and Driver
R-0407013 Gearshift Device Bushing Puller
R-0007761 Universal Handle for Pullers and Installers
T-0207928 Retai ...
0.0053