Chevrolet Sonic Repair Manual: Engine Oil Pressure Indicator Switch Replacement
|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the air conditioning compressor. Refer to Air Conditioning Compressor Replacement. |
|
|
1 |
Oil Pressure Switch Caution: Refer to Fastener Caution. Procedure
Disconnect the oil pressure switch electrical wiring harness connector and remove the switch. Tighten
30 Y (22 lb ft) |
Brake Warning System Description and Operation
Brake Warning Indicator
Brake Warning Block Diagram
B80Park
Brake
SwitchB20Brake
Fluid Level
SwitchK9Body
Control
ModuleP16 ...
Engine Oil Pressure Indicator Switch Replacement
Engine Oil Pressure Indicator Switch Replacement
Callout
Component Name
1
Engine Oil Pressure Indicator Switch
C ...
Other materials:
Brake Fluid Level Indicator Switch Replacement
Removal Procedure
Disconnect the brake fluid level indicator switch
electrical connector.
Using a small, flat-bladed tool, lift the locking
tab on the underside of the brake fluid level indicator switch (1) and remove
the switch.
Inspect the maste ...
Scrub Radius Description
Ideally, the scrub radius is as small as possible. Normally, the SAI angle and
the centerline of the tire and the wheel intersect below the road surface, causing
a positive scrub radius. With struts, the SAI angle is much larger than the long
arm/short arm type of suspension. This allows the S ...
Timing Belt Rear Cover Installation
Re-cut the 4 rear timing belt cover threads.
Install the timing belt rear cover (1).
Caution: Refer to Fastener Caution.
Note: Service may offer bolts that are not microencapsulated.
If this is the case apply thread lock agent to the bolt. If fastener is
...
0.0069