Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Evaporative Emission Canister Replacement (Steel Tank)

Chevrolet Sonic Repair Manual / Powertrain / Engine / Emissions / Evap / Evaporative Emission Canister Replacement (Steel Tank)

Removal Procedure

    Remove the evaporative emission canister bracket fasteners (1).
  1. Remove the evaporative emission canister bracket fasteners (1).

  2. Disconnect the purge solenoid valve electrical connector (1).
  3. Disconnect the evaporative emission canister vent hose (2).
  4. Disconnect the evaporative emission canister pipes (3). Refer to Plastic Collar Quick Connect Fitting Service
  5. Remove the evaporative emission canister (4).

  6. Release the retaining tab (1) and remove the evaporative emission canister (2).
Installation Procedure

    Slide the evaporative emission canister (3) into the evaporative emission
  1. Slide the evaporative emission canister (3) into the evaporative emission canister bracket (2) until the retaining tab (1) snaps into position.

  2. Install the evaporative emission canister (4) into position.
  3. Connect the evaporative emission canister pipes (3). Refer to Plastic Collar Quick Connect Fitting Service
  4. Connect the evaporative emission canister vent hose (2).
  5. Connect the purge solenoid valve electrical connector (1).

  6. Install the evaporative emission canister bracket fasteners (1) and tighten to 10 Y (89 lb in)

    .

Evaporative Emission Canister Replacement
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the EVAP canister cover fasteners (1) and cover (2). Warn ...

Evaporative Emission Canister Purge Solenoid Valve Replacement
Evaporative Emission Canister Purge Solenoid Valve Replacement Callout Component Name 1 Purge Pipe Fittings (Qty: 2) ...

Other materials:

System Operation
The vehicle has a Traction Control System (TCS) and StabiliTrak®, an electronic stability control system. These systems help limit wheel slip and assist the driver in maintaining control, especially on slippery road conditions. TCS activates if it senses that any of the drive wheels are spinni ...

Hood Rear Weatherstrip Replacement
in Hood Rear Weatherstrip Replacement Callout Component Name 1 Hood Rear Weatherstrip Procedure The hood rear weatherstrip is held in place with 10?€‰plastic retainers that are part of the air inlet grille. ...

Brake Rotor Surface and Wear Inspection
Warning: Refer to Brake Dust Warning. If the inboard friction surface of the brake rotor is not accessible, reposition and support the caliper with the brake pads. Refer to Front Disc Brake Pads Replacement. Clean the friction surfaces of the brake rotor with denatured alcohol, or ...

© 2014-2024 Copyright www.csmans.com
 
0.013