Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Evaporative Emission Canister Vent Solenoid Valve Replacement

Chevrolet Sonic Repair Manual / Powertrain / Internal Combustion Powertrain Control / Engine Control / General / Evaporative Emission Canister Vent Solenoid Valve Replacement



Evaporative Emission Canister Vent Solenoid Valve Replacement

Callout

Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the evaporative emissions canister. Refer to Evaporative Emission Canister Replacement.

1

Evaporative Emissions Canister Vent Solenoid Valve

Procedure

Turn the evaporative emission canister vent solenoid valve counter clockwise 45 degrees and remove the solenoid from the evaporative emissions canister.

Evaporative Emission Canister Replacement (Steel Tank)
Removal Procedure Remove the evaporative emission canister bracket fasteners (1). Disconnect the purge solenoid valve electrical connector (1). Disconn ...

Evaporative Emission Control System Description
Typical Evaporative Emission (EVAP) System Hose Routing Diagram (1) Evaporative Emissions (EVAP) Purge Solenoid Valve (2) EVAP Canister ...

Other materials:

Driver Information Center (DIC)
The DIC display is in the instrument cluster. It shows the status of many vehicle systems. The controls for the DIC are on the turn signal lever. 1. SET/CLR: Press to set or clear the menu item displayed. 2. : Turn the band to scroll through the menu items. 3. MENU: Press to display the DI ...

When to Add Engine Oil
1.8L Shown, 1.4L Similar If the oil is below the minimum mark on the dipstick, add 1 L (1 qt) of the recommended oil and then recheck the level. See “Selecting the Right Engine Oil” in this section for an explanation of what kind of oil to use. For engine oil crankcase capacity, see Cap ...

Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto the balancer. The pilot bore (on the hub side of the wheel) is machined to be concentric to very tight non - standard tolerances. The bottom cap bore is not machined to this same degree of precision. Accurate mac ...

© 2014-2022 Copyright www.csmans.com
 
0.007