Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Exhaust Manifold Heat Shield Replacement (LUW)

Chevrolet Sonic Repair Manual / Powertrain / Engine / Engine Block / Exhaust2 / Exhaust Manifold Heat Shield Replacement (LUW)



Catalytic Converter Heat Shield Replacement

Callout

Component Name

Warning:

Refer to Exhaust Service Warning.

Preliminary Procedures

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement.
  3. Disconnect the heated oxygen sensor connector.

1

Catalytic Converter Heat Shield Bolt

Caution:

Refer to Fastener Caution.

Tighten


15 Y (11 lb ft)

2

Heated Oxygen Sensor Harness Bracket

3

Catalytic Converter Heat Shield Bolt (Qty: 2)

Tighten


8 Y (71 lb in)

4

Catalytic Converter Heat Shield

Exhaust Manifold Heat Shield Replacement (LUV)
Exhaust Manifold Heat Shield Replacement Callout Component Name Warning: Refer to Exhaust Service Warning. ...

Exhaust Rear Muffler Heat Shield Replacement
Exhaust Rear Muffler Heat Shield Replacement Callout Component Name Preliminary Procedure Disconnect the exhaust system hangers ...

Other materials:

Safety Locks
The rear door safety locks prevent passengers from opening the rear doors from inside the vehicle. Manual Safety Locks If equipped, the safety lock is located on the inside edge of the rear doors. To use the safety lock: 1. Insert the key into the safety lock slot and turn it so the slot is ...

Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the rear storage area. 1. Lift the trim cover. 2. Remove the tire sealant canister (1) and the compressor (2). To store the tire sealant canister and compressor: 1. Attach the sealant/air hose to the sealant canister inlet valve. 2. Return the ...

Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Ensure that the steering wheel is set in a straight ahead position. Loosen the tie rod jam nut (1). Adjust the toe to specification by turning the inner tie rod (2). Refer to Wheel Alignment Specifications. Caution: Refer to Fastener Caution. Tighten the t ...

В© 2014-2026 Copyright www.csmans.com
 
0.0069