Chevrolet Sonic Repair Manual: Exhaust Rear Muffler Replacement (LUV,LUW)
Special Tools
CH-6614 Chain Pipe Cutter
For equivalent regional tools, refer to Special Tools.
- Removal Procedure
-
Warning:
Refer to Exhaust Service Warning.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Cut the exhaust rear muffler (2) with the CH-6614 pipe cutter at position (1).
- Remove the rear exhaust muffler (2) from the exhaust isolators (1).
- Sand smooth the front exhaust pipe for ease of installation.
- Installation Procedure
-
- Install the new rear exhaust muffler (2) into the exhaust isolators.
- Position the exhaust front pipe (3) into the exhaust muffler clamp.
- Install the rear exhaust muffler (2) into the exhaust muffler clamp
and tighten the bolt (1) to 50 Y (37 lb ft)
.
- Lower the vehicle.
- Start the engine and check for exhaust leaks.
Caution:
Refer to Fastener Caution.
Note:
There are 3 different exhaust muffler clamps depending on the diameter of the exhaust pipe.
Exhaust Rear Muffler Heat Shield Replacement
Exhaust Rear Muffler Heat Shield Replacement
Callout
Component Name
Preliminary Procedure
Disconnect the exhaust system hangers ...
Fuel System
...
Other materials:
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat.
2. Remove the wheel cover, if the vehicle has one, to reach the wheel bolts.
3. Turn the wheel nuts counterclockwise to loosen them. Do not remove them yet.
4. Place the jack at the position marked with a half circle.
5. In ...
Liftgate Strut Replacement
Liftgate Strut Replacement
Callout
Component Name
1
Liftgate Strut
Warning: When a lift gate hold open device is being removed
or installed, provide alternate support to avoid the possibility of
damage ...
Engine Front Cover and Oil Pump Disassemble
Engine Front Cover Disassemble
Remove the intake camshaft position sensor bolt (1).
Remove the intake camshaft position sensor (2) and the seal ring (3).
Remove the exhaust camshaft position sensor bolt (6).
Remove the exhaust camshaft posi ...
0.0104