Appearance Care
LocksSIR Identification Views
The SIR Identification Views shown below illustrate the approximate location
of all SIR components available for the vehicle. This will assist in determining
the appropriate SIR Disabling and Enabling for a given service procedure, refer
to SIR Disabling and Enabling.
Supplemental Inf ...
Thrust Washer and Bearing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Caution: Do not allow the bearings to spin. Turn them slowly by
hand. Spinning the beari ...
Engine Coolant Thermostat Housing Installation
Caution: Refer to Engine Coolant Thermostat Housing Caution.
Clean sealing surface.
Install a NEW engine coolant thermostat housing seal.
Install the engine coolant thermostat housing (2).
Caution: Refer to Fastener Caution.
Note: Screw in the 4 ...