Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Exterior Lighting

The exterior lamp control is on the instrument panel to the outboard side of


The exterior lamp control is on the instrument panel to the outboard side of the steering column.

O : Briefly turn to this position to turn the automatic light control off or on again.

AUTO: Turns the headlamps on automatically at normal brightness, together with the following:

all lamps except the headlamps.: Turns on the parking lamps including
all lamps except the headlamps.

with the parking lamps and instrument panel lights. A warning chime sounds if the : Turns the headlamps on together
with the parking lamps and instrument panel lights. A warning chime sounds if the driver door is opened when the ignition switch is off and the headlamps are on.

to turn the lamps on or off. See: : For vehicles with fog lamps, press
to turn the lamps on or off. See:

Interior Lighting
Dome Lamps The dome lamp controls are in the headliner above the rear seats. : Press to turn the lamps off, even when a door is open. : When the button is returned to the middle position, t ...

Windshield Wiper/Washer
Sedan Hatchback The windshield wiper/washer lever is on the right side of the steering column. Move the lever to one of the following positions: HI: Use for fast wipes. LO: Use for slow wipes ...

Other materials:

Questions and Answers About Safety Belts
Q: Will I be trapped in the vehicle after a crash if I am wearing a safety belt? A: You could be— whether you are wearing a safety belt or not. Your chance of being conscious during and after a crash, so you can unbuckle and get out, is much greater if you are belted. Q: If my vehicle has ai ...

Seat Belt Latch Stop Installation
Seat Belt Latch Stop Installation Callout Component Name Preliminary Procedure Locate the hole in the seat belt webbing where the original seat belt stop button was located. If the original hole in the seat belt webbing i ...

Park - Engine Running (Gen 1)
When the gear selector lever is in the Park (P) position, fluid is drawn into the pump through the transmission fluid filter assembly. Line pressure is then directed to the following valves: Fluid Pressure Directed in Preparation for a Shift Manual Valve Mechanically controlled ...

© 2014-2026 Copyright www.csmans.com
 
0.0075