Immobilizer Operation
Convex MirrorsFog Lamps (RS)
To replace the front fog lamp bulb:
1. Locate the fog lamp located under the front fascia.
2. Remove the cap from the back of the fog lamp assembly.
3. Disconnect the electrical connector from the fog lamp bulb assembly.
4. Remove the bulb by turning it counterclockwise and pulling it straight ...
Roof Panel Joint Finish Molding Replacement
Roof Panel Joint Finish Molding Replacement
Callout
Component Name
Caution: Refer to Exterior Trim Emblem Removal Caution.
Preliminary Procedures
Begin at the rear edge of the roof panel joint finish molding an ...
Battery Negative Cable Disconnection and Connection
Battery Negative Cable Disconnection and Connection
Callout
Component Name
Preliminary Procedures
Turn on the radio and record all of the radio pre-set stations.
Ensure that all lamps and accessories are turned off.
Tu ...