Chevrolet Sonic Owner's Manual: Finish Damage
Quickly repair minor chips and scratches with touch-up materials available from your dealer to avoid corrosion. Larger areas of finish damage can be corrected in your dealer's body and paint shop.
Sheet Metal Damage
If the vehicle is damaged and requires sheet metal repair or replacement, make
sure the body repair shop applies anti-corrosion material to parts repaired or replaced
to restore corrosion protecti ...
Chemical Paint Spotting
Airborne pollutants can fall upon and attack painted vehicle surfaces causing
blotchy, ring-shaped discolorations, and small, irregular dark spots etched into
the paint surface. See “Finish Care ...
Other materials:
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Battery Current Sensor Replacement
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Disconnect the battery current sensor from the body harness connector.
Unclip the battery current sensor from the battery tray.
Remove the battery ...
Fuel Tank Filler Pipe Replacement
Removal Procedure
Remove the bracket fastener (1).
Lift and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the fuel tank filler pipe bracket fastener (1).
Disconnect the vent hose (2). Refer to
Plastic Collar ...
0.0051