To flash the high beams, pull the turn signal lever all the way toward you. Then release it.
Headlamp High/Low-Beam Changer
Daytime Running Lamps (DRL)Rear Wiper Blade Replacement
1. Pull the wiper arm a short distance away from the glass (1).
2. Pull the blade out from the arm (2).
It may require extra effort to remove the old blade.
3. Once the blade pin disengages from the wiper arm, remove the wiper blade by
sliding the pin out of the guide hole.
4. Reverse the ...
Front Side Door Check Link Replacement
iii!
Front Side Door Check Link Replacement
Callout
Component Name
Preliminary Procedure
Remove the front side door trim panel. Refer to Front Side Door Trim
Replacement.
1
Front Side Door Check ...
Neutral - Engine Running (Gen 1)
When the gear selector is moved to the Neutral (N) position, the hydraulic and
electrical system operation is identical to Park (P) range. However, if Neutral
is selected after the vehicle was operating in Reverse (R), the normally-high 35R
pressure control solenoid 2 is commanded OFF and the ...