Chevrolet Sonic Repair Manual: Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components:
- For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly.
- For a 2-piece carpet assembly with a cotton or a fiber padding, replace the padding only. While the carpet is out of the vehicle, dry the carpet using the method described below.
- For a 1-piece carpet assembly bonded to a foam padding or attached to a synthetic padding, dry the carpet using the method described below.
- For a 2-piece carpet assembly with a synthetic padding, dry the assembly using the method described below.
- If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture.
- Blot the face of the carpet with a towel in order to absorb as much moisture as possible.
- Point a fan at the affected area and air dry the carpet.
Floor Panel Carpet Replacement
Floor Panel Carpet Replacement
Callout
Component Name
Preliminary Procedures
Remove front seats. Refer to Driver or Passenger Seat ...
Other materials:
Rear Side Door Adjustment (4 Door Notch Back 69)
Rear Side Door Adjustment
Callout
Component Name
1
Rear Side Door
Caution: Refer to Fastener Caution.
Procedure
Loosen the rear door hinge bolt?€‰(Qty:?€‰4) to adjust the rear
door.
A ...
Fuel Tank Fuel Pump Module Replacement
Special Tools
EN-48279 Fuel Sender Lock Ring Tool
For equivalent regional tools, refer Special Tools.
Removal Procedure
Relieve the fuel system pressure. Refer to Fuel Pressure Relief
Remove the fuel tank. Refer to Fuel Tank Replacement.
Disconnect the electrical c ...
Turbocharger Coolant Feed Pipe Replacement (LUV)
Turbocharger Coolant Feed Pipe Replacement
Callout
Component Name
Preliminary Procedure
Remove the turbocharger. Refer to Turbocharger Replacement.
1
Turbocharger Fastener
Caution: Refer to ...
0.0063