Chevrolet Sonic Repair Manual: Frame and Structure
- Body Side Frame Rocker Reinforcement Replacement
- Driver or Passenger Seat Back Cushion Frame Replacement
- Driver or Passenger Seat Cushion Frame Replacement
- Drivetrain and Front Suspension Frame Replacement
- Front Compartment Front Insulator Cover Replacement
- Front Wheelhouse Liner Inner Front Extension Replacement (Left SIde)
- Front Wheelhouse Liner Inner Front Extension Replacement (Right SIde, LWE, LUW)
- Front Wheelhouse Liner Inner Front Extension Replacement (Right Side, LUV)
- Front Wheelhouse Liner Replacement (Front)
- Front Wheelhouse Liner Replacement (Rear)
- Rear Wheelhouse Liner Replacement (Hatchback - Left)
- Rear Wheelhouse Liner Replacement (Hatchback - Right)
- Rear Wheelhouse Liner Replacement (Sedan - Left)
- Rear Wheelhouse Liner Replacement (Sedan - Right)
- Rear Wheelhouse Panel Liner Extension Replacement
- Special Tools
- Center Pillar Reinforcement Replacement
- Drivetrain and Front Suspension Frame Skid Plate Replacement
Rear Side Door Window Weatherstrip Replacement (Sedan)
Rear Side Door Window Weatherstrip Replacement
Callout
Component Name
Preliminary Procedures
The rear door side window weatherstrip ...
Body Side Frame Rocker Reinforcement Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note ...
Other materials:
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Clutch and Differential Housing Disassemble
Special Tools
M-680770 Universal Sliding Mallet
R-0007758 Holding Fixture
R-0407008 Counter Shaft Bearing Remover
R-0407010 Input Shaft Needle Bearing Puller and Driver
R-0407013 Gearshift Device Bushing Puller
R-0007761 Universal Handle for Pullers and Installers
T-0207928 Retai ...
Oil Pan Installation
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces from old sealing material, dirt, oil and grease.
Note: The sealing bead should be applied close to the inner edge
of the oil pan. Take care that the oil suctio ...
0.0056