|
Callout |
Component Name |
|---|---|
|
Warning: Refer to Eye Protection Warning. Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. |
|
|
1 |
Headlamp Bolt Caution: Refer to Fastener Caution.
10?€‰Y (89?€‰lb?€‰in) |
|
2 |
Front Bumper Fascia Guide Rivet (Qty:?€‰2) Special Tools
BO-594-A Hand Rivet Tongs For equivalent regional tools, refer to Special Tools. |
|
3 |
Front Bumper Fascia Guide Procedure
Slide the guide forward to release the front retainer from the fender. |
Front Bumper Fascia Center Support Bracket Replacement
Front Bumper Fascia Opening Lower Cover ReplacementElectronic Brake Control Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the ECU is not properly configured with the correct
calibration software, the ECU will not control all of the vehicle features
properly.
Ensure the programming tool is ...
Front Wheel Drive Shaft Seal Replacement - Right Side
Front Wheel Drive Shaft Seal Replacement - Right Side
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the front wheel drive shaft from the tran ...
Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral
(N) position, the transmission will provide engine braking. In this operating range,
the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine
braking mode, the following changes occur with ...