Chevrolet Sonic Repair Manual: Front Bumper Fascia Replacement

Chevrolet Sonic Repair Manual / Body / Body Exterior / Bumpers / Front Bumper / Front Bumper Fascia Replacement

Front Bumper Fascia Replacement
Callout	Component Name
Preliminary Procedures Remove the radiator opening upper cover. Refer to Front Opening Upper Cover Replacement. Remove the front bumper opening lower cover. Refer to Front Bumper Fascia Opening Lower Cover Replacement. Remove the front wheelhouse front liner. Refer to Front Wheelhouse Liner Replacement. Disconnect the ambient air temperature sensor from the lower grille.
1	Front Bumper Fascia Screw (Qty:?€‰2) Caution: Refer to Fastener Caution. Tighten 6?€‰Y (53?€‰lb?€‰in)
2	Front Bumper Fascia Lower Screw (Qty:?€‰2) Tighten 6?€‰Y (53?€‰lb?€‰in)
3	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the bracket to separate the joint slightly. Spray a mixture of soap and clean drinkable water into the joint, to act as a lubricant. Insert a small flat-bladed tool or plastic trim tool into the fascia slot and depress the tabs one at a time. Pull the front bumper fascia carefully forward and outward in order to release the retaining tabs from the front bumper fascia guides. Disconnect the electrical connectors. On reassembly of the front fascia to the vehicle, ensure the 4?€‰support retainers on the inside of the radiator grille bumper are in position to the front bumper fascia center support bracket.

Front Bumper Fascia Opening Lower Cover Replacement

Front Bumper Fascia Opening Lower Cover Replacement Callout Component Name 1 Front Bumper Fascia Opening Lower Cover Pus ...

Front Bumper Fascia Tow Eye Access Hole Cover Replacement

Front Bumper Fascia Tow Eye Access Hole Cover Replacement Callout Component Name 1 Front Bumper Fascia Front Tow Eye Acc ...

Other materials:

Front Seat Outboard Seat Back Airbag Replacement
Front Seat Outboard Seat Back Airbag Replacement Callout Component Name Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: ...

Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should be performed before replacing the bushing, shaft, and in some cases, the component which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces before inspecting for damage. Any of the followin ...

Manual Transmission Shift Lever and Selector Lever Cable Adjustment
Remove the floor console. Refer to Front Floor Console Replacement. Lift upward and disengage (do not remove) both cable lock adjusters (1) to release the internal cable assembly, one for each side. Block the shift control housing, push the selector lever ( ...

0.0071